Digico SD5 Bedienungsanleitung

SD5 Operation Manual0-1User Manual - Getting StartedTo be read in conjunction with the SD Series Software ReferenceUser Manual Version C for Software

SD5 - Getting Started1-6To the left of the Channel Strip panel are more channel controls: When pressed, the 2nd function button allows access todiffer

SD5 - Getting Started1-71.4 Hardware Configuration1.4.1 Connections ...Detailed

SD5 - Getting Started1-81.5 Software ConfigurationThe SD5 has a default setup which means that the new user need not get involved in configuring the d

SD5 - Getting Started1-9To adjust any of the channel allocations, touch on the associated channel count box, and either enter a number using the pop-u

SD5 - Getting Started1-101.5.4 Opto V220 (DiGiRacks) and Opto V221 (SD Racks) ...SD Series consoles can operate with either one of two diffe

SD5 - Getting Started1-111.5.7 Manual Conforming of Racks...With a Rack selected in the left hand port sel

SD5 - Getting Started1-121.5.8 Rack Sharing...In a multi-console system where Ra

SD5 - Getting Started1-131.6 Saving and Loading Sessions1.6.1 Save As New File ...When y

SD5 - Getting Started1-141.7 Audio SyncTo access the Audio Sync Panel, touch the Setup Menu button, followed by Audio Sync. The following window will

SD5 - Getting Started1-151.8 Routing Basics1.8.1 Selecting Inputs & Outputs...All channel input, o

SD5 Operation Manual0-2Copyright © 2014 Digico UK LtdAll rights reserved.No part of this publication may be reproduced, transmitted, transcribed, sto

SD5 - Getting Started1-16Note: The outputs for the channel being routed are locked out of the signal listNote also that the console views all routes a

SD5 - Getting Started1-171.9 Channel Processing1.9.1 Dynamic EQ...The EQ secti

SD5 - Getting Started1-181.9.2 Dynamics ...The dynamics are accessed by to

SD5 - Getting Started1-191.9.3 Auxiliaries ...The auxiliaries can be accesse

SD5 - Getting Started1-201.10 The MatrixTo open the Matrix Inputs panel, touch the Matrix button on the Master Screen. The window that opens allow yo

SD5 - Getting Started1-211.11 Control GroupsAny number of input channels and output channels can be connected to one or more of the 24 possible Contro

SD5 - Getting Started1-221.12 Multi-channel formatsIf you are working in Surround, or using another multi-channel format, you can create LCR, LCRS and

SD5 - Getting Started1-231.13 Solo SetupThe SD5 Solo panel is accessed from a button at the top of the Master Screen. Some of the controls on this pan

SD5 Operation Manual0-3Contents1.1 The Console ... ...1-11.2 Manual Over

SD5 Operation Manual0-41.12 Multi-channel formats... ...1-221.13 Solo Setup...

SD5 - Getting Started1-11.1 The ConsoleThe Digico SD5 consists of a worksurface, an audio engine and a range of onboard inputs and outputs. This can b

SD5 - Getting Started1-21.3 Before You StartThere are certain general operating principles and terms that should be understood before continuing to us

SD5 - Getting Started1-31.3.2 Layers and Banks ...The SD5's worksurface is divided

SD5 - Getting Started1-4Pop-ups are closed by pressing the box in the top right-hand corner of the pop-up, marked CLOSE or CANCEL (or by pressingCAN o

SD5 - Getting Started1-5The 2 rows of twelve encoders and buttons immediately below the touchscreen (shown above) refer to the channels with whichthey